Guidance
Fixing & Setup Guideline
INSTALLATION GUIDELINES
- Doors are adjustable, allowing for trimming up to 12mm per side. It is essential to trim both sides equally for proper alignment.
- Subsequent to trimming all sides should be primered or sealed with wood sealant and must be applied immediately.
- Bottom of the door must be painted / polished before installation of the door is done.
- Hinges must be aligned before fitting the door, to avoid bending. It is recommended that you fix two hinges in the upper portion on the door with a gap of 6 inches from each other and by leaving a gap of 12 inches from the top, for the first hinges. The rest of the hinges should be placed equa distance in the rest of the door length.
- We will not be held liable for any of the damages due to the wind or any external forces.
- If the doors are trimmed more than 12mm in width or height from any side, it may result in Distortion, Warping, bending and waviness and Trudoor shall not be held responsible for such alterations.
- Bathroom doors must be fitted with teak or hardwood lipping at the bottom to prevent moisture absorption. If not followed manufacturing warranty shall become void and Trudoor shall not be responsible for the same.
- 3mm space between the frame and door must be provided on all sides of the door shutter. This is to accommodate minor movements of the door frames.
STORAGE GUIDELINES
- Store flat on a level surface in a clean, dry, well ventilated building. Protect from dirt, water and abuse. Allow air circulation. Cover the top door with a moisture barrier.
- Doors should not be subjected to abnormal or sudden variations in heat, dryness or humidity, and should not be exposed to direct sunlight. Recommended humidity and temperature are 25% – 55% RH and 50° F – 90° F (10° C – 32° C).
WARNING
- Distortion Warping, bowing and waviness, can appear as a result of incorrect topcoat (paints or stains), improper finishing techniques and or finishing conditions. These are caused by but are not limited to incorrect topcoat, watered down paints, high humidity environments, excessive application of paints, and doors not being acclimated properly.
- Please read and understand the entire procedure before attempting to finish your doors.
- Trudoor does not warrant any coating unless applied by Trudoor. Any damage caused by or resulting from the application of a stain or paint will not be responsible.
- Trudoor’s accountability is only for its product. If it is found that there is a manufacturing defect, Trudoor shall repair only for its product and will not be responsible for any value addition what so ever.
- Any complaints regarding material shall be submitted in writing within 7 days of receipt.
- The decision of Trudoor Technical team in determining whether a defect is a manufacturing defect or an application defect will be treated as final.